18 Hours

March 2012

1. 5.0 Hours 	Change of DTS software to switch the displacement conditioners from AC to DC so we
		can use analog temposonics for displacement feedback on the DTS2500KN.

2. 2.0 Hours	Check on triple power connections on the BTS Temposonics to see if ok to use for DTS2500KN
		Tempo power. Checked OK and then made sure we had enough current for all Tempos. That's OK too.

3. 1.5 Hour	Cable check for rest of the cables for DTS2500KN. All OK.

4. 1.0 Hour	Rexroth Valve setup for BTS 493.15 3-stage valve driver. AC excitation = 0.0 Volts.

5. 0.5 Hour	How to get out of Simulation mode.

April 2012

6. 2.5 Hour	assist polarity of signals and calibration of stroke and load of DTS2500KN.

7. 2.0 Hours	create calx.doc word document to get stroke calibration right.

8. 0.5 Hour	load cell calibration and initial tuning

9. 3.0 Hours	mess-up on valve balancing - NOT charged for several days lost on this account. Sum will NOT
		show these hours.

10. 0.5 Hour	correct valve balance adjustment - turn off 1 valve hydraulics at a time.

11. 1.0 Hour	explanation of Temposonics vibration sensitivity.

May

12. 1.5 Hours	running problems with the DTS2500KN. Looking at run data.


Total = 21 Hours - 3 Hours = 18 Hours total for DTS2500KN project.